First, prior to operation
1. check whether the parts of the machine are loose and whether the pneumatic components leak.
2. the first test run the machine, to see the machine work is not normal, there is no abnormal voice.
3. turn on the power switch indicator to see if the power indicator is abnormal and whether the machine will leak.
4. make sure that the cutting stock is in common with the instructions specified in the work instruction.
Two. Operation rules
1. turn on the power supply and pull the wire cutting machine through the feeding wheel to the right side of the blade.
2. set the required standards (depending on the number of the materials).
3. first cut one quality for two tests. Check whether you need to break the wire.
4. Press the Start button when the settings are complete to start the job.
5. after the first line of QC inspection line fits the quality of the standard production, the production operation is started according to the "beginning". In the process of production, there are abnormal conditions, immediately press the pressing middle stop key, and immediately to the department class (Group) long or machine repair processing.
Three. Precautions
1. the line machine must be operated by the professional trainer. The operator must be familiar with the general performance and structure of the machine, and master the precaution, discrimination and emergency treatment of the equipment.
2. during the production process, the machine should be suspended when the machine is out of the machine.
3. during the operation of the machine, fingers should not be close to the knife holder and chuck to prevent injury.
4. when the trouble is found, the operation should be stopped immediately, the circuit is short circuited, the smoke is smoked, the power switch should be cut off when the electricity is leakage, and the trouble should be removed from the rear, and the equipment can not be operated with excessive overload