Usual maintenance of automatic terminal machine is very important, we sometimes can not rush to let the machine continue to work, whether people or machines have a certain load range, once beyond this range, over time will constitute a variety of problems, reduce machine life. Fully automatic terminal machine daily maintenance, can extend its use of life, the overall operation efficiency, let the following Zhansheng Automatic Technology Co., Ltd. to introduce the daily maintenance and repair of fully automatic terminal machine.
1, before starting the motor, it is necessary to make the clutch in a state of disengagement, and the flywheel is in the direction of idling.
2, machines and electrical equipment often insist on cleanliness, monotonicity and no leakage. If you find faults and anomalies in your homework, it is necessary to stop and see the repair immediately. It prevents the disease from happening and avoids the loss of machine parts or motor burn.
3, the automatic terminal machine should be punctual for comprehensive repair.
4, blocking machine overload operation. The fabricated device must not exceed the limit of pressure.
5, mold clamping must be accurate and firm. Mold space is reasonable, often insist on sharp cutting edge.
6, machine smooth points, as well as the various parts of the conflict, carefully and diligently refueling, each class must not less than 2 times.
7, often check whether all parts of the machine work normally, whether the connecting pieces and fasteners are loose. If there is any loosening, tighten it in time. If organic parts are found worn, it is necessary to replace them in time.
Terminal machine should be careful when using.
1, in the process of operation, if the demand is out of the post, it is necessary to shut off the power supply.
2, non designated personnel block private debugging or disassembly of machine parts.
3. If a terminal is stuck in the die during operation, it is necessary to use scissors or pick-up needle to remove it before continuing operation.
4. When replacing the terminal, it is necessary to disconnect the power supply first, and then carry out the replacement operation to prevent the replacement in the machine operation.
5. In the course of operation, the power supply of the machine is not disconnected, forbid finger or any part of the body to enter the punching range, in order to avoid industrial accidents.
6. In the course of operation, if the machine is abnormal, turn off the power supply first, and promptly ask the maintenance personnel for maintenance and debugging, in order to avoid more serious damage.