Specification for safe operation of coaxial stripper
According to the coaxial stripping machine produced by the exhibition, the degree of automation of the coaxial stripping machine in the industry is still very high, so it can be operated by professional technicians only through brief instructions and exercises, and the operation of the coaxial stripping machine is very simple, the cost of machine maintenance is low, so it is a kind of machine. Very good wiring harness processing equipment. What are the safe operation rules of the coaxial stripper? Let's show you.
1. Preparation of coaxial stripper before operation.
1. check whether the parts are loose and see if the accessories are correct.
2. try the machine to see if the machine is working normally. Is there any abnormal movement?
3. turn on the power to see if the power indicator is normal and see if the machine is back.
4. confess whether the processed wire is in the process planning of this machine.
Two. Operation details of coaxial stripper
1. According to the requirements of the process documents, the length of stripping cable, the length of stripping core wire, adjust the upper and lower (left and right) knife position, check whether the compressed air supply is normal, and adjust the air flow of the cylinder, plug in the power supply, with the foot switch control equipment to start work.
2. Check the length of the product and the quality of the core line to ensure the conformity of the process documents. Check the qualified products, then start up the normal production.
3. during the stripping process, the hand can not enter the inner part of the shield so as to prevent the machine from hurting people.
4. Half-stop, please pull out the power plug, so that people out of the machine power failure, in order to prevent others from trampling on the foot switch to form a clip injury.
5. if you need to replace the wire stripping blade, you must first cut off the electricity and stop the gas before you can replace it.
Three. Points for attention in the use of coaxial stripper.
1. The operator of the coaxial stripper must be coached and trained by a professional to operate. The operator should understand the general function and structure of the machine, master the prevention of equipment defects, distinguish and deal with urgently.
2. during the production process, the machine should be suspended when the machine is out of the machine.
3. during the working process, fingers should not be near the knife holder and chuck to prevent injury.
4. When the defect occurs, the machine should stop immediately. The circuit is short-circuited, smoke is emitted, and the power supply should be blocked when the electricity leakage occurs.